ULB-R150S Bicolor Reflection Glass Level Gauge with square bar
|Glass material||Red Borosilicate glass with single groove|
|Body||square bar 46×42|
|Visual range||H=L -230mm|
|Heating steam jacket joints||R3/8 or special requirements|
|Heating steam pressure||≤1.0MPa|
|Wetted material||20 304 or special requirements|
|Material of covers||ZG375|
|Thickness of covers||22mm|
|Vent and drain outlet||M12×1.5(female thread) or valve|
|Material of covers||Carbon steel|
ULB –T150S glass level gauge is produced basing on the principle of
communicating vessels for on-site indicating instrument, the
instrument will be introduced medium within the container inside
itself, and through the transparent glass to read the actual height
of the liquid level. Instrument built with safety valve ball up and
down, so when the glass was accidentally destroyed, under the
pressure of container, ball automatically turns off the liquid flow
channel to avoid excessive liquid leakage.
These level gauges are particularly suitable for liquids:
- very fluid
- non-corrosive for glasses
It is a variation of transparent level gauges, however equipped
with two glasses with groove , fitted with suitable coloured
filters. The sharp reading is given by the contrast between the
bright colour of filters in the lower part containing liquid and
the colour of upper part of visible window.
Continuous level indication without power supply.
Direct indication of the level.
Individual design and corrosion resistant materials make the
products suitable for a broad range of applications.
Chemical, petrochemical industry, oil and natural gas
extraction(on-and offshore),shipbuilding, machine building, power
generating equipment, power plants.
Oil and gas, heat transfer and refrigeration systems, plants for
Transparent level gauges are suitable for almost all installations.
In fact they permit:
- the use of mica shields to protect the glass form the corrosive
action of the process fluid;
- the observation of interface;
- the observation of the liquid colour.
- can be used as a reference to check, or calibrate, other level
- Not affected by the chemical or electrical properties of the
process liquid. Specific gravity, dielectric, conductivity, surface
turbulence, vapor, foam, etc. no longer needs to be considered.
The main body of the sight glass level gauge, contains the liquid
For the clamping of the sight glass plate
Chambered sealing between the liquid channel and the environment
Sight glass plates per QB2112
Mechanical protection between cover and glass
Hold the forces form the internal pressure
Standard lengths of sight glass plates per QB2112, width 34 mm,
thickness 17 mm
Valve heads isolate the vessel from the sight glass level
indicator. They consist of the valve body and the head piece. They
are actuated by a valve with quick closing lever or hand-wheel. In
general, they are fitted with a ball-check valve as a safety
The ball-check valve should prevent any major spillage from the
sight glass level indicator in the event of any glass or mica
breakage or other sizable leakge. For this purpose there is, under
the valve seat(pressure>0.5bar).in this way, the flow is sharply
reduced. The closing of the valve presses the ball back into its